SXT 5HND Point to Point MPLS

This is an example shows how the bridge be done using MPLS instead of WDS.

Bridge:
/interface wireless
set wlan1 adaptive-noise-immunity=ap-and-client-mode band=5ghz-onlyn basic-rates-a/g=””
country=australia disabled=no frequency=5180 frequency-mode=manual-txpower
ht-ampdu-priorities=0,1,2,3,4,5,6,7 ht-extension-channel=below-control ht-rxchains=0,1
ht-txchains=0,1 mode=bridge rate-set=configured ssid=wifinederland.nl supported-rates-a/g=””
wireless-protocol=nv2
/ip address
add address=172.16.0.1/30 interface=wlan1
/mpls ldp
set enabled=yes lsr-id=172.16.0.1 transport-address=172.16.0.1
/mpls ldp interface
add interface=wlan1
/interface vpls
add name=vpls1 remote-peer=172.16.0.2 vpls-id=1:1 disabled=no
/interface bridge add name=bridge1
/interface bridge port
add bridge=bridge1 interface=ether1
add bridge=bridge1 interface=vpls1
/mpls interface set 0 mpls-mtu=1522

CPE:
/interface wireless
set wlan1 adaptive-noise-immunity=ap-and-client-mode band=5ghz-onlyn basic-rates-a/g=””
country=australia disabled=no frequency=5180 frequency-mode=manual-txpower
ht-ampdu-priorities=0,1,2,3,4,5,6,7 ht-extension-channel=below-control ht-rxchains=0,1
ht-txchains=0,1 mode=station rate-set=configured ssid=wifinederland.nl supported-rates-a/g=””
wireless-protocol=nv2
/ip address
add address=172.16.0.2/30 interface=wlan1
/mpls ldp
set enabled=yes lsr-id=172.16.0.2 transport-address=172.16.0.2
/mpls ldp interface
add interface=wlan1
/interface vpls
add name=vpls1 remote-peer=172.16.0.1 vpls-id=1:1 disabled=no
/interface bridge add name=bridge1
/interface bridge port
add bridge=bridge1 interface=ether1
add bridge=bridge1 interface=vpls1
/mpls interface set 0 mpls-mtu=1522