5ghz mpls

SXT 5HND Point to Point MPLS

This is an example shows how the bridge be done using MPLS instead of WDS. Bridge: /interface wireless set wlan1 adaptive-noise-immunity=ap-and-client-mode band=5ghz-onlyn basic-rates-a/g=”” country=australia disabled=no frequency=5180 frequency-mode=manual-txpower ht-ampdu-priorities=0,1,2,3,4,5,6,7 ht-extension-channel=below-control ht-rxchains=0,1 ht-txchains=0,1 mode=bridge rate-set=configured ssid=wifinederland.nl supported-rates-a/g=”” wireless-protocol=nv2 /ip address add address=172.16.0.1/30 interface=wlan1 /mpls ldp set enabled=yes lsr-id=172.16.0.1 transport-address=172.16.0.1 /mpls ldp interface add interface=wlan1 /interface vpls add Read more about SXT 5HND Point to Point MPLS[…]

wifinederland sxt point to point

Mikrotik Simple point to point Networks with SXT

Bridge config – Master /interface bridge add mtu=1500 name=bridge1 /interface wireless security-profiles set [ find default=yes ] supplicant-identity=master add authentication-types=wpa-psk,wpa2-psk eap-methods=”” \ management-protection=allowed management-protection-key=12345 \ mode=dynamic-keys name=profile1 supplicant-identity=”” \ wpa-pre-shared-key=12345 wpa2-pre-shared-key=12345 /interface wireless set [ find default-name=wlan1 ] band=5ghz-a/n channel-width=20/40mhz-Ce \ country=netherlands disabled=no frequency=5200 mode=bridge rx-chains=0,1 \ security-profile=profile1 ssid=wifinederland_5ghz_lijn1 tx-chains=0,1 /ip ipsec proposal set [ Read more about Mikrotik Simple point to point Networks with SXT[…]